High End Breakage on Your Ring Frame? Check the Spindles First

When end breakage climbs, the first suspect is usually the fibre or the draft settings. But in many mills the real culprit sits lower: the spindle. A spindle that vibrates, runs slow or wobbles adds irregular tension to every metre of yarn it spins — and tension spikes break ends.

Five spindle-side checks

1. Vibration. Touch the bolster housing — a healthy spindle runs smooth and quiet. Buzzing or rattling means worn bearings or a bent blade.
2. Bolster oil. Low or degraded oil overheats the bolster and slows the spindle; check levels and oil condition.
3. Spindle tape. A loose or glazed tape lets the spindle slip, so its speed — and the yarn twist — varies. See our notes on spindle tape slipping.
4. Spindle alignment. A spindle that is not centred under the ring tilts the traveller and chafes the yarn.
5. Worn wharve. A scored or polished wharve grips the tape poorly and runs erratic.

What to do about it

Work position by position: mark the high-break spindles, run the five checks, and replace or service only what fails. Blanket replacement wastes money; targeted replacement fixes the break rate. If several spindles show the same wear, the whole section is due — read 7 signs your spindles need replacement.

Need help choosing?

Send us your machine make and model — we will match the correct Vindex component from our 1,500+ variants. Contact us or WhatsApp +91 89805 05555.